Xyllomer help system online: shipsSYNOPSIS
This is no command, just information.
DESCRIPTION
Use the following commands for any ship:
enter ship|<shipname|type>
to enter a ship, either your own, a public one or one you
have been invited onto.
leave ship|<shipname|type>
to leave a ship
NOTE: If you leave a ship in midst of the ocean, you might
drown!
look at <ship>
to find out about a ship nearby
shout <message>
to communicate with ships nearby
Use the following commands for travelling with a ship-line:
wait for <shipname>
wait for the arrival of a ship and enter it automatically
when it's arriving
wait for [next] harbour
wait for the ship's arrival at the next harbour and leave
it automatically
wait for <harbour>
wait for the ship's arrival at the given harbour and leave
it automatically.
Use the following commands for a player-owned ship:
sail
to leave a harbour/the coast
n|s|w|e|nw|ne|sw|se
to sail on the ocean
sail <destination>
to sail from the ocean to the coast, river, jetty or
another 'special' exit
sail to <destination>
If you bought a sea-map in the sailors supply shop you
can record a route from one harbour to another and recall
it with this command.
drop anchor
drop your anchor, to avoid drifting away. this will of
course only work fully near the cost. In the midst of
the ocean, the drifting of you ship will be only slowed!
You drop anchor automatically when you leave a ship you
commandeer in a harbour
weigh anchor
lift your anchor again to be able to sail on.
You will automatically weigh anchor when you order your
crew to sail
make <name> captain
use this command to allow someone else to commandeer one
of your ships. This command will stay active even over
Armageddon and will have to be revoked explicitly!
relieve captain
to revoke the captainship of someone who has been captain
of one of your ships.
You will have a command buffer which will store a certain amount
of commands for you, so you can type ahead. The associated
commands are:
show buffer
to show the current contents of your command buffer
clear buffer
the clear the current remaining command buffer
set command buffer size to x
to set the maximum number of commands being stored in the
buffer. default buffer size is 10, maximum is 40
The 'sailing' skill will not be required to use player-owned
ships, however that skill can become vitally important in unknown
or dangerous situations, like sailing in storms, with damaged
rigging and so on. a good knowledge in sailing will also increase
the speed of your ship.
The basic speed of a ship is determined by its type, the current
loading, the condition of hull and rigging, the wind and, as
mentioned before, the sailing skill of its captain.
Usually a map of the surrounding area is displayed. If you don't
want this, you can use
set map on|off to display the map or not.
If you happen to set a wrong course, e.g. sailing in a direction
where instead of ocean you would meet a continent, your ship's
hull could get damaged from attempting to enter that dangerous
shallow water, or you could end up sitting on a sand bank, having
to wait for the next high tide to pull you free.
sstatus
to get vital information about your ship, like damage of
rigging and hull, current number and status of crew,
loadings of weapons and goods etc.
Since water is always aggressive on wood, your ship will get
damaged by aging too. You will be informed by your
second-in-command about desertion, fees and damage due to aging
when you re-enter your ship after some time.
You need a crew for your ship. You can find sailors in pubs
through-out the world. Note that the ship your are recruiting the
sailors for should be at a harbour near to your recruiting place.
Commands are:
recruit <amount> for <ship>
to recruit sailors for your ship. The ship has to be in a
harbour near the pub, else the sailors will need ages
to get there.
sack <amount> sailors
to sack sailors; works only aboard a ship
NOTE: You will have to pay your sailors even if you are
not sailing or intend being away for a while. So getting
rid of them in time might be quite friendly on your purse
cpay <number of cc>
to set the weekly ! pay a single sailor of your crew.
average pay per week is 6 copper coins. (works aboard a
ship only). this will increase the crews morale, starting
with the next pay day.
Your crew will need large amounts of water to survive long sea
journeys. Water can be ordered and loaded from the trading posts
or the sailing shops. You can also buy rum at these locations.
cspend <amount of liters per man>
to spend <amount of liters per man> of rum to your crew.
this will raise the morale of your crew.
NOTE: This is LITER per man! So e.g. 'cpend 8' with a
crew of 20 is 8*20 liter = 40 Gallons!
The morale of your crew is very important. Should someone un-
authorised enter your ship, your crew will attack that person. the
combat skills of your crew will depend on the current morale. Morale
also is important concerning desertation and performance in ship
combat.
Since you will have to pay not only your crew but also the harbour
offices, you will be allowed to store a certain amount of money on
your ship. the total sum may however not exceed 10 platinum coins
or crew*500 cc, whichever is more.
mstore <amount>
use this to store money on your ship, use a negative
amount to withdraw money from the ship. NOTE: if your
crew gets unhappy with you because of bad pay and/or low
morale, some or all may desert you, taking some, if not
all, of the stored money with them
(s)check load
to check the current storage of your ship. you will get a
more detailed summary than with sstatus
To allow fellow players on your ship use the following:
sinvite
to check who is allowed to enter your ship
sinvite <name>
allow a person to enter your ship.
suninvite <name>
disallow a person to enter your ship.
'suninvite all' to disallow everyone to enter your ship.
This only works, when you are the only one on board -
otherwise you just will uninvite only those you see.
stop fight
when your sailors are in fight with someone, this will
command them to stop the fight
Use the following commands at a harbour-office:
inquire about <ship>
to find out owner and home-port of a ship. if the ship you
inquire about is a public ship, you will be given that ships
route.
change homeport of <ship>
to change the homeport of a ship to the harbour where the
office is
locate <ship>
will help you to find your ship, in case you forgot where
you left it.
NOTE: if you leave your ship in the middle of the ocean,
your ship stays there! You will have to ask someone else
to ship you to your ship then.
sell <ship> to <name>
you can now sell you ship to other players.
The harbour office will demand a fee of 1% of the ships
value to update the books etc. you will have to check for
the money from the player yourself.
rename <ship>
for a small fee this command allows you to rename your
ship. the books of the office will be updated accordingly.
Ships can be bought at several shipyards. Use the following
commands in a shipyard:
order <type of ship> called <name>
to order a ship of the given type.
NOTE: In order to be able to order a ship, you will have
to be registered in the region of the shipyard!
ask about ship
to check if your ship is already built/repaired
repair ship
to get information about the repair costs for your ship.
NOTE: the more damaged your ship is, the more the repair
will cost, there is however a minimum repair cost.
A last word on harbours. Some harbours will be larger than others, so
you will be able to sail within some harbours. Leaving your ship at
the harbour itself will cost you quite some fees. But you will be
able to load and unload without restriction there. Leaving your ship
at quays will greatly reduce the harbour fees, but alas, you will not
be able to load and unload at all quays.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
@ |